SikaGrout Deep Pour – 20kg

Description

SikaGrout®-Deep Pour is a ready mixed, high quality, Portland cement grout that expands in two stages (Class A and C), to counteract the shrinkage normally associated with Portland cement grouts.
SikaGrout® Deep Pour is a blend of Portland cement, carefully selected and graded aggregates and Sika Admixtures, enabling it to achieve high strengths in short times, making SikaGrout® Deep Pour suitable for grouting of large sections and deep pours of up to 500mm.

USES

• Mass grouting/concreting
• Machine bedplates
• Anchor bolts.
• Bridge bearing pads.
• Pre-cast concrete sections.

CHARACTERISTICS AND ADVANTAGES

• Shrinkage compensating properties,
• High early strengths.
• High 28 day strengths.
• Good flow characteristics.
• Adjustable consistency.
• Good impact and thermal resistance.
• Non corrosive to steel or iron.
• Lab tested in accordance with AS 1478.2

COLOUR
Grey Powder

PACKAGING
20kg bags

MIXING
SikaGrout® Deep Pour must be mechanically mixed using a mechanical grout mixer and suitable mixing container. It is recommended to mix a full bag in clean container using an electric drill / spiral drill and spiral mixer at a speed of approximately 500 rpm.

Pour the correct amount of water into a suitable clean mixing container. While stirring slowly with drill and spiral mixer, add the complete bag of powder into the water. Mix continuously for 3-5 minutes to achieve a uniform and lump free smooth consistency.

Do not add more water than the maximum specified.

APPLICATION
SikaGrout® Deep Pour can be placed by gravity flow or by pump. It is essential that proper placing on the job site is practised to ensure placement is completed without problems. Sufficient labour, grout and equipment must be present to ensure continuous placement.

Gravity Flow
Mixed grout should be poured one side of the void to avoid air entrapment. Grout is best poured over short distances to ensure this. Use a suitable header box, maintaining the grout head at all times to ensure continuous flow. To facilitate grout compaction and top plate contact, use rodding, tamping or flexible strapping in short strokes while maintaining an adequate head of grout. Do not vibrate as this will cause segregation. Any adjacent machinery or equipment causing vibration should be shut down until initial set (5-6 hrs).

Pumping
When pumping SikaGrout-Deep Pour, ensure the pump is suitable for the grout consistency and for the distance and height it is to be pumped. A positive displacement pump is recommended. Place grout by pumping into the farthest corner, filling the space gradually. Ensure that air is not entrapped under the base plate. Maximum aggregate size is 5mm. Ensure that selected pump is suitable for pumping this size of aggregate.

CURING TREATMENT
Suitable curing methods such as plastic sheet, wet hessian, liquid membrane etc. must be used to protect the freshly applied grout from the drying effects of sun and wind. Curing must commence immediately after placement, and continue for at least 7 days. Curing is vital to the ultimate performance of grout as it allows optimum strength development and ensures tight contact with the baseplate.

SikaGrout Deep Pour Product and Safety Data Sheets

 

SikaGrout® Deep Pour – Sika’s Website

Colour accuracy disclaimer: We have taken care to display the most accurate visuals of our products. However, we are not responsible for the colour accuracy of the device you are viewing our swatches on. These variations arise due to different computer monitors and devices (make, model and technology, as well as resolution, contrast and brightness control settings) in much the same way a scan will differ from an original image and a colour photocopy. Furthermore, coatings can exhibit variation in perceived colour depending on gloss level and application method. If you require a very specific colour match, please make your selection via actual swatches and colour boards available at our showroom.

Product Disclaimer: Ensure you read all product, technical and safety data sheets prior to application as liability falls on the applicator. All products must be applied in accordance with manufacturer’s recommended method.