Aqua Blok WPU 15Ltr Grey

Curing time

Allow a minimum of 12 hours curing prior to applying finished covering, and a minimum of 3 days to cure before flood testing. Allow longer in cool or cold weather conditions.

Waiting time to overcoating

Allow Aqua BlÖk® WPU 2-4 hours to dry between coats. Allow longer in adverse weather conditions.

APPLICATION INSTRUCTIONS

Substrate Preparation

All surfaces to be waterproofed must be firm, clean, dry, structurally sound and smooth. All grease, oil, wax, curing compounds, dust, loose material, laitance and other contaminants must be removed. All projections and rough spots should be dressed off to achieve a level surface. The substrate surface must be continuous and not pond water.

Priming Guide:

Concrete

Allow at least 28 days for the concrete to cure. Concrete should be left with an open surface – standard wood float or broom finish. All traces of curing compounds or sealers should be removed prior to application. Old concrete must be thoroughly cleaned and washed and allowed to dry. The surface should be even unless falls are incorporated where required, imperfections to be repaired with a suitable Sika® MonoTop repair mortar.

Sand / Cement Screeds and Renders

The screeds and / or renders must conform to the appropriate standard and should be left with a wood float finish and left to cure for at least cure for 7 days.

Building Boards

Water resistant plasterboard, fibrous cement sheeting, marine ply must be solidly fixed in accordance with the manufacturer’s instructions specifically for tiling. The area must be primed with ECO SYSTEMS^® Eco Prime WB, particularly where a jointing compound has been used.

Particleboard

Particleboard must be fixed in accordance with the manufacturer’s instructions specifically for tiling and meet minimum deflection standards for tiling. Secure floor with additional fixings and wedges, sand any surface contamination after initial preparation. The area must be primed with ECO SYSTEMS^® Prep ‘N’ Prime.

Static Crack & Sheet Joint Treatment

For static cracks 0.5 – 3mm wide rout and clean thoroughly before filling with Sika^® Neutral Cure silicone to form a Bond Breaker, For all sheet joints and seams clean thoroughly and fill with Sika^® Neutral Cure silicone to form a Bond Breaker, apply a liberal coat of Aqua Blök^® WPU extending 100mm either side of the crack and place Aqua Blök^® reinforcing bandage into the wet membrane, press down firmly to ensure good contact, apply another liberal coat of Aqua Blök^® WPU to the entire surface to embed the bandage. For dynamic cracks, expansion joints and control joints contact Sika^® technical service for advice.

BOND BREAKER / CONNECTOR SEALANT

Suitable bond breaker: Any Sika neutral cure silicone sealant

Suitable connector sealant: SikaFlex Fillet or SikaFlex construction AP

Cleaning of Equipment

Clean tools and equipment with clean water while the material is still wet. Cured coating can only be removed mechanically.