Sikadur®-330 is a 2-component, thixotropic epoxy based impregnating resin and adhesive.
Uses & Advatages
Sikadur®-330 is used as:
Impregnation resin for SikaWrap® fabric reinforcement for the dry application method
Primer resin for the wet application system
Structural adhesive for bonding Sika® CarboDur® plates into slits
CHARACTERISTICS AND ADVANTAGES
Easy mix and application by trowel and impregnation roller
Manufactured for manual saturation methods
Excellent application behaviour to vertical and overhead surfaces
Good adhesion to many substrates
High mechanical properties
No separate primer required
Component A: white paste
Component B: grey paste
Components A + B mixed: light grey paste
5 kg (A+B)
Substrate must be sound and of sufficient tensile strength to provide a minimum pull off strength of 1.0 N/mm2 or as per the requirements of the design specification.
See also the “Method Statement for SikaWrap® manual dry application” Ref 850 41 02.
See the “Method Statement for SikaWrap® manual dry application” Ref 850 41 02.
Mix components A+B together for at least 3 minutes with a mixing spindle attached to a slow speed electric drill (max. 300 rpm) until the material becomes smooth in consistency and a uniform grey colour. Avoid aeration while mixing. Then, pour the whole mix into a clean container and stir again for approx. 1 more minute at low speed to keep air entrapment at a minimum. Mix only that quantity which can be used within its pot life.
Bulk packing, not pre-batched:
First, stir each component thoroughly. Add the components in the correct proportions into a suitable mixing pail and stir correctly using an electric low speed mixer as above for
Colour accuracy disclaimer: We have taken care to display the most accurate visuals of our products. However, we are not responsible for the colour accuracy of the device you are viewing our swatches on. These variations arise due to different computer monitors and devices (make, model and technology, as well as resolution, contrast and brightness control settings) in much the same way a scan will differ from an original image and a colour photocopy. Furthermore, coatings can exhibit variation in perceived colour depending on gloss level and application method. If you require a very specific colour match, please make your selection via actual swatches and colour boards available at our showroom.
Product Disclaimer: Ensure you read all product, technical and safety data sheets prior to application as liability falls on the applicator. All products must be applied in accordance with manufacturer’s recommended method.